Auto Replace

Auto Replace is a built-in feature that allows to automatically replace certain characters or words before the message is sent out. Auto Replace has three modes:

  • OFF
  • ON
  • FULL

OFF mode

When the Auto Replace is set to OFF mode, no replacements are done on Messente's side and the message will be forwarded exactly as it was received.

ON mode

In ON mode, the custom replacements table is applied to the message that can be configured in the Developers » Auto Replace settings page.

Tip: The custom replacements table can also have words, not just characters - this way you have fully customizable replacements logic.

FULL mode

In FULL mode, Messente makes sure that all characters, that are not present in GSM alphabet, are replaced automatically with the closest possible character that can be found.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.